Adjustable mirror mount, The first.

 

This is the first one I'm making and it is for the gantry, which seems to dictate a few different heights on other parts of the machine.

I mostly copied this design from mirror mounts I saw for sale on Ebay. The plate with the mirror attached is pulled tight against the thumbscrews by a pair of springs. It all pivots on a ball bearing.

 

I decides to go with 25mm diameter mirrors because it allowed for the best chance of alignment to happen at all!

I started by using a 1" hole saw to cut the recess for the mirror to sit in. I just cut 2mm or so in to the 6mm thick aluminium.
Then I drilled out the rest of the material to a 22mm hole. It wandered all over the place as can be seen from the back view. Not too big a deal in this case, just looks poor.
For the ball bearing hole and thumb screw holes I used the cone of a centreing drill. it gives a chatter free conical hole, unlike a counter sink in my drill press.
Perhaps not the best cone angle.
I'm using a 6.5?mm dia ball bearing here. It was just one I had lying/rolling around. It seems okay.

The adjusting screws are M4 by .5, the fine version of the standard M4 thread. I did so because I read someone giving out about a similar set-up which was using a standard thread here and it was very difficult to get an accurate adjustment with it.(this was on a commercial, cheapo Chinese laser cutter.)

I cut the springs from a long spring I had and bent the loops up. They work well. 4mm dia with wire of .9mm I think.They are held in place with TIG filler rod pins.
I made the thumb screws on the lathe. Turned from 6mm brass rod, down to M4 by .5!(with a die). I should have faced off, then centre drilled the ends of the bar before I started, as I need to put a small ball bearing into the end of the thumb screw to stop it biting into the aluminium.

The mirror will be held in place with a ring held in with three M3 socket heads. To be cut on my router from 2mm aluminium sheet.